Oscar Schmidt AT Autoharp Tuning Wrench

---

Wrench for tuning Autoharp.

---

Tips for Tuning Autoharp

Start by turning on the tuner and attaching it to the autoharp if it has a clamp or setting it on the table on which you are working.

• Begin tuning on the lowest string, F, in the “middle” octave. This is important because this octave is the foundation for each of the other octaves.
• Pluck the cord that is being tuned, the tuner will say what the cord is and if it is too flat or too sharp based on a small dial on the screen.
• Using the tuning wrench turn the tuning pin counterclockwise to lower the pitch or clockwise to raise the pitch.
• Only turn the pin a hair at a time, little movements will make a big change in the pitch.
• After each small turn of the pin, pluck the string to make sure you didn't go too far.
• Repeat these steps on all the strings on your autoharp.

Model:	AT-U
Manufacturer:	Oscar Schmidt